12 / 46
51346-007 GB/2020-08
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • [email protected]
1.4.2.2 RS 232 - Pinning
Communication is fundamentally conducted on the basis of the BANDELIN protocol with
the following settings:
SubD
pin
Name of signal
ML-pin
Remark
1
1
Not connected!
2
TxD
3
SCI TxD
3
RxD
5
SCI RxD
4
--
7
Not connected!
5
GND
9
SCI GND
6
2
Not connected!
7
4
8
--
6
9
--
8
The protocol and set of instructions (user information) can be made available by the
manufacturer upon request.
1.5
Warning and safety instructions
General
• Keep the ultrasonic bath out of the reach of children and of persons who have not been
instructed in its operation by reference to these instructions.
• We will not o
ff
er any guarantee for damages to the ultrasonic bath or oscillating tank,
or to the objects to be treated, as a result of use of inadequate disinfection agents or
detergents.
• Do not expose the ultrasonic bath directly to sunlight and do not position it in the vicinity
of heat sources.
• Keep the surface of the ultrasonic bath and operating elements clean and dry.
• Do not expose the ultrasonic bath to corroding in
fl
uences.
• Only move the ultrasonic bath when it is empty. During transportation, the rubber
stoppers are to be plugged into the tank's inlet and outlet.
•
Empty the ultrasonic bath only while turned o
ff
.
• Ultrasonic baths adhere to prescribed EMC limit values, such that it can be assumed
that the electromagnetic radiation emanating from the units is harmless to humans.
A binding statement for wearers of implants can only be made at the place of work
and together with the implant manufacturer. In case of doubt, information regarding
the allowable electromagnetic exposure level is to be obtained from the implant
manufacturer.
Operation
• Observe ambient and set-up conditions, see chapter 1.4.
• Only plug in the ultrasonic bath to an outlet with a grounded socket.
• Do not operate the ultrasonic bath without
fl
uids.
• Do
not
fi
ll the oscillating tank with hot water (> 30 °C). The
fi
lling temperature should be
between 15 and 25 °C.