![background image](http://html1.mh-extra.com/html/bandelin/dt-31/dt-31_operating-manual_3758423019.webp)
1686-000 GB/2021-03
19/52
Preparation for operation
/4
4.3 Performing a function test
Requirement
• The ultrasonic bath has adapted to the climatic conditions at the
setup location for at least 2 hours.
Procedure
1. Insert the mains plug for the ultrasonic bath into an earthed
mains socket.
2. Press the on/off button to switch the ultrasonic bath on.
3. Switch the ultrasound on briefly. Do this by pressing the start/
stop button. After 1 to 2 seconds, press the start/stop button
again to switch off the ultrasound.
Result
» A noticeable noise can be heard when the ultrasound is switched
on.
Contact our service department if you cannot hear any noise.
A foil test should be performed before the first use. This is used to
document the effectiveness of the ultrasound. See chapter
6.3 Performing the foil test
.
4.4 Rinsing out the ultrasonic oscillating tank
Rinse the ultrasonic oscillating tank thoroughly with water before
using it for the first time.