43
User Manual
IT8000 3/8” TIE
-LOK DATA TOOL
IT7000 1/4” TIE
-LOK DATA TOOL
ITC800 CONTROL SYSTEM
Document # P80080 Rev. C.3
© Copyright
BAND-IT-IDEX, Inc. 2024
All rights reserved
All rights reserved
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
MAINTENANCE
MAINTENANCE SCHEDULE
The IT8000/IT7000 tool requires periodic maintenance to prevent malfunction or damage. Refer to the table
below for recommended maintenance intervals of critical tool components. Intervals may vary depending on the
operating environment.
Table 6
To maximize performance and extend tool life:
•
Do not use degreaser on any part of the tool.
•
Do not spray any lubricant or cleaner into the pneumatic system.
•
Do not remove factory-applied lubrication from inside tool unless performing a thorough maintenance
procedure and then replacing with clean lubricant immediately.
•
Follow preventative maintenance and parts replacement instructions at appropriate service intervals.
•
For maintenance beyond what is described in this manual, contact BAND-IT.
Components
Recommended
Service
Recommended Interval
Page Ref.
Backing Wheel
Grease pin
Every 20,000 clamps
44
Inspect and replace if
worn
100,000 clamps
49
Tension Wheel
Clean with wire brush
(included w/ tool)
McMaster PN:7092T18
Every 20,000 clamps
45
Inspect and replace if
worn
50,000 clamps
49
Punch
Inspect and replace if
worn
100,000 clamps
48
Knife
Grease
McMaster PN:
1208K22
Every 20,000 clamps
44
Inspect and replace if
worn
50,000 clamps
46
Head Assembly
Inspect and replace if
worn
100,000 clamps
47