baltur TBG 1100 ME, User Instruction Manual

Page: 17 / 114

15 / 22
0006160030_201306
ENGLISH
AIR REGULATION SERVOMOTOR
MAINTENANCE
The burner does not require any particular maintenance, it is recom-
mended at least to carry out the following operations at the end of
the heating season:
• Clean the air shutters, the air pressure switch with pressure
intake and the pipe.
• Check the conditions of the ionisation electrode.
• Have the boiler cleaned and, if necessary, also the chimney by
specialized personnel (stove repairer); a clean boiler is more
efficient, lasts longer and is quieter.
• For gas burners, periodically check that the gas filter is clean.
• In order to clean the combustion head, its components must
be disassembled. Be careful during the reassembly operations
to exactly centre the gas diffuser with regard to the electrodes,
making sure that they are not earthed, which would result in the
locking of the burner. It should also be checked that the ignition
electrode spark occurs only between the electrode itself and the
perforated sheet disk.
Periodically analyse combustion gases and check emissions val-
ues.
Check that all components of the combustion head are in good
condition, have not been deformed by high temperatures and are
free from impurities or deposits deriving from the installation en-
vironment or from poor combustion. If it is necessary to clean the
combustion head, take out its components according to the proce-
dure described below:
• unscrew the anchoring screws (N), and open the ventilating
body;
• pull out the ignition (I) and ionization cables (M) from their
electrode terminals (L);
• unscrew the screw (R) from the lung (P);
• pull out the entire mixer unit in the direction shown by the
arrow. Having completed the maintenance work, replace the
combustion head, following in reverse order the operations
described above, after having checked the correct position of
the electrodes of ignition and of ionization (see 0002937680).