Bally Revenge from mars Pinbal 2000, Operation Manual

Page: 40 / 132

1-28
SET LOCATION I.D.
This utility allows the operator to show the game's location on printouts. Press the Enter button to
open the utility. Use the Up and Down buttons to move the cursor and select letters. Press the
Enter button to lock in desired letters.
UPDATE GAME CODE CODE (You will typically want to run the latest update).
Use this menu to enable or disable the update game code (stored in the PRISM board FLASH
memory).
Enable Updated Code
If the update game code is enabled, the system will run the last version of update game code
installed (REFERENCE SOFTWARE UPDATES IN NEW FEATURES OF PINBALL 2000).
Disabled Updated Code
If the update game code is disabled, the system will run the version of game code located in the
original PRISM board ROMs.
WARNING TO THE OPERATOR.
In early releases of the Revenge from Mars game code ROMs, DO NOT perform the
Disabled Updated Code. Doing so will cause your game to run in Free Only Mode and the
UPDATE GAME CODE utility menu will not allow the updated game code to be enabled.
If you accidentally disable the update game code, do one of the following:
1) Plug a keyboard into the keyboard port (located near the computer case in the backbox) or,
2) Plug a computer terminal into the COM 1 port (located near the coin door).
Then, at the command (%) prompt type the following:
% fupdate enable
to re-enable the Updated Game Code.
Note: This operation takes about 15 seconds to complete.
CLEAR AUDITS
Press the Enter button to clear the all of the audits.
CLEAR COINS
Press the Enter button to clear the Earnings Audits.
RESET HIGH SCORES
Press the Enter button to clear the High Score to Date Table.
SET CLOCK
Press the Enter button to activate the clock. Use the Up and Down buttons to change the time,
then press the Enter button to lock in the time.
FACTORY ADJUSTMENT
Press the Enter button to restore the adjustments to factory settings.
FACTORY RESET
Press the Enter button to restore the adjustments to their factory setting, clear the Audits, Reset
the High Score, and the Location I.D.
INSTALL PRESETS
Press the Enter button to open the utility. Use the Up and Down buttons to move the cursor and
select from the available Presets. When the desired Preset is selected, press the Enter button to
lock it in. Press the Escape button, during the 'countdown' to retain the original setting and return
to the Utilities Menu. See the Preset Table on the next page.