Balluff BVS HS-P Series, Operation Manual

Page: 239 / 314

239
www.balluff.com
4
References
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
4.1.2 RS-232/USB
COM
Parameters
Intercharacter
Delay This parameter specifies the intercharacter de
lay be
tween the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in 10ms
increments. A setting of zero specifies no delay.
To set the delay:
1 Determine the desired setting in milliseconds.
2 Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with leading
zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
3 Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming Mode.
4 Go to page 38 and scan the barcode: SELECT INTERCHARACTER DELAY SETTING.
5 Scan the appropriate two digits from the keypad in Appendix D: Keypad , that represent the
duration which was determined in the steps above. You will hear a two-beep indication after
the last character.
6 Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit.
This completes the procedure. See Table Intercharacter Delay Setting Examples for some exam-
ples of how to set this feature.
Intercharacter
Delay Setting
Examples
NOTE
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
STEP ACTION EXAMPLES
1 Desired Setting 50ms 150ms 600ms 850ms
2
Divide by 10 (pad with
leading zeroes to yield
two-digits)
05 15 60 85
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT INTERCHARACTER DELAY SETTING
5
Scan Two Characters
From
Appendix D:
Keypad
‘0’ and ‘5’ ‘5’ and ‘0’ ‘6’ and ‘0’ ‘8’ and ‘5’
6 Scan ENTER/EXIT PROGRAMMING MODE