Intended use
The BTL magnetostrictive linear position sensor, together
with a machine controller (e.g. PLC), comprises a position
measuring system. It is intended to be installed into a
machine or system and used in the industrial sector.
Flawless function in accordance with the specifications in
the technical data is ensured only when using original
Balluff accessories. Use of any other components will void
the warranty.
Opening the BTL or non-approved use are not permitted
and will result in the loss of warranty and liability claims
against the manufacturer.
General safety notes
Installation
and
startup
may only be performed by
trained specialists.
The
operator
is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the BTL will not result
in hazards to persons or equipment.
If defects and unresolvable faults occur in the BTL, take it
out of service and secure against unauthorized use.
Downloading further instructions
A complete user's guide can be downloaded from the
Internet at
www.balluff.com
or requested via e-mail from
.
Dimensions and function
The BTL contains the waveguide which is protected by an
aluminum housing. A magnet is moved along the
waveguide. This magnet is connected to the system part
whose position is to be determined.
The magnet defines the position to be measured on the
waveguide.
Electrical connection
Pin assignment of S115 (view from
above on BTL connector), 8-pin M12
circular plug
Pin
BTL6-P11_-...
1
+Init
2
+Start/Stop
3
–Init
4
Must remain free
5
–Start/Stop
6
GND
1)
7
20…28 V
8
Must remain free
1) Reference potential for supply voltage and EMC-GND.
BTL6-P11 _ -M _ _ _ _ -A1-S115
Magnetostrictive Linear Position Sensor – Profile Style
english
2) Not included in scope of delivery
3) Unusable area
4) Dimensions see section Installation
~60
~60
M12x1
73
73
~250
~250
21 A
21
9
A
18
60
50
Ø 5.5
37
B
18
19
28
16
37.6
Ø 4.2
55-4
5
Ø 30
C
Slot
Bracket
2)
BTL6-A-MF03-K-50
Magnet
2)
BTL6-A-3801-2
Nominal length
= Measuring range
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive.
File No.
E227256
1
3)
4)
4)
4)
4)
3)
