Balluff BNI EIP-508-105-Z067, Configuration Manual

Page: 81 / 88

www.balluff.com 37 english
Application recommendation for a Port X in the context of
the other designation variables (see Fig. 6-32):
–
d
evice
a
liaS
– name of the device that shows what
function the sensor executes (e.g. rear left end switch ,
temperature at boiler floor , etc.)
– M
Ode
p
in
4 – selection of the actuation (e.g.
Deactivated
,
IO-Link [Manual]
,
IO-Link [Autostart]
or
Digital In/Out . Depending on the selection, further
dialog fields open, which require an input (e.g. when
the IO-Link [Manual] option is selected).
If no backup and validation are required on the
port, the option IO-Link [Autostart] can be
selected for which the validation and backup are
switched off.
– v
alidatiOn and bacKup
– If for the point Mode Pin 4 the
option IO-Link [Manual] has been selected,the following
mandatory fields marked with “*” must be completed.
Selection Validation Backup
No device
check
– –
V1.0
Compatible
Check conformity
between
connected
IO-Link device
(1.0) and default
value using
Device and
Vendor ID
–
V1.1
Compatible
–
V1.1
Backup
and
recovery
Automatic backup
of parameter
values. Changes to
the current
parameter values
are saved.
The parameter
values are restored
when a similar
IO-Link device is
connected.
V1.1
Recovery
No
automatic
backup of
parameter values.
Changes to the
current parameter
values are not
saved.
The parameter
values are restored
when a similar
IO-Link device is
connected.
– c
ycle
t
iMe
– if the IO-Link [Manual] or IO-Link
[Autostart] options are selected for point Modus Pin 4 ,
the desired communication cycle can be set by
selecting the corresponding value from the dropdown
list.
– M
Ode
p
in
2 – Is defined as d
igital in
/
Out
.
6
WebUI/web interface (continued)
Fig. 6-32:
M
OduS
p
in
4
selection options dialog and Port 2:
Configuration dialog of the iO-l
inK
[M
anual
] option
The port configuration is not permanently stored.
After a reset, reboot or a deenergized phase, the
settings are lost.
It is not possible to reconfigure a port configured
as an IO-Link directly to another IO-Link mode.
The respective port must be deactivated
beforehand.
It is also not possible to change the validation
information for IO-Link [Manual] without first
deactivating the port.
BNI EIP-508-105-Z067
Network interface