B-2 Parameter Tables
MN762
Param
#
Access
Parameter Name
Description (Range)
Factory
Setting
User
Setting
P24
RW
Analog/Digital Output
Digital output mode
0: Drive enabled
1: Drive healthy
2: Motor at target speed
3: Drive tripped
4: Motor speed >= limit
5: Motor current >= limit
6: Motor speed < limit
7: Motor current < limit
Analog output mode
8: Motor speed
9: Motor current
8
P25
RW
Relay output limit
0.0 to 100.0% For Speed; 0 to 200% for Current
100.0
P26
RW
Skip Frequency
P-05 to P-06
0.0
P27
RW
Skip Frequency Band
0 to P-06
0.0
P28
RW
Restart Mode
0: Minimum Speed
1: Previous speed
2: Minimum speed (Auto-run)
3: Previous speed (Auto-run)
1
P29
RW
Auto Restart Attempts
Edge-r
Auto-0
Auto-1-5
Auto-0
P30
RW
Analog Input Offset
-500.0 to 500.0%
0.0
P31
RW
Brake After Stop
0 to 60.0 seconds
0.0
P32
RW
Brake Before Start
0 - The drive accelerates to speed without delay.
1 - Applies DC braking when run command is
issued. The amount of time is set in P31 and
the amount of braking in P18. (The drive will
then accelerate.)
0
P33
RW
Decel2 Fast Stop
0 to 25 seconds
0.00
P34
RW
Brake Chopper Enable
0: Disabled
1: Enabled
2: Enabled without s/w protection
0
P35
RW
Serial Comms address Modbus
enable / baudrate select
Trip enable / delay
Addr: 0 (disable) to 63
OP-buS, 9.6, 19.2, 38.4, 57.6, 115.2 kBPS
0 (no trip), t 30, 100, 1000, 3000
(ms) r 30, 100, 1000, 3000 (ms)
Adr 1
OP-BuS
t3000
P36
RW
V/F Frequency Adjustment
0 to P-03
0.0
P37
RW
V/F Voltage Adjustment
0 - P-01
0
P38
RW
User PI Proportional Gain
0.1 - 30.0
1.0
P39
RW
User PI Integral time constant
0.0s - 30.0seconds
1.0
P40
RW
User PI feedback mode
0: Direct
1: Inverse
0
P41
RW
User PI reference select
0: Digital
1: Analog
0
P42
RW
User PI digital reference
0 - 100.0%
0.0
P43
RW
User PI feedback select
0: 2nd analog input
1: 1st analog input
2: motor load current
0
P44
RW
2nd analog input format
(Analog In 2)
0-10V, 0-20mA,
t 4-20mA, r 4-20mA,
t 20-4mA r 20-4mA
u0-10
P45
RW
Parameter access lock
0: Parameters can be changed
1: Read-only
0
P46
RW
Thermal Overload Value
Retention
0: Disabled
1: Enabled
0
Table B-1 Parameters Sorted by Parameter Number (Cont.)
