![background image](http://html1.mh-extra.com/html/balboa-water-group/spatouch2/spatouch2_user-manual_3540143023.webp)
Manufactured under one or more of these patents.
U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,834 b2, Canadian Patent: 2342614,
Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
42281_A | Compatible with SpaTouch 1 & 2
23
03.17
Most messages and alerts will appear at the bottom of the
normally used screens. Several alerts and messages may be
displayed in a sequence.
After the pump has been running for 1 minute, the
temperature will be displayed.
Possible freezing condition
A potential freeze condition has been detected, or the Aux
Freeze Switch has closed. All water devices are activated.
In some cases, pumps may turn on and off and the heater
may operate during Freeze Protection. This is an operational
message, not an error indication.
The water is too hot – M029*
The system has detected a spa water temp of 110°F (43.3°C)
or more, and spa functions are disabled. System will auto re-
set when the spa water temp is below 108°F (42.2°C). Check
for extended pump operation or high ambient temp.
The water level is too low
This message can only appear on a system that uses a water
level sensor. It appears whenever the water level get too low
(or the water level sensor is disconnected), and automatical-
ly disappears when the water level is adequate. Pumps and
the heater turn OFF when this message appears.
*M0XX is a Message Code. Codes like this will be seen in the Fault Log
– – – –
°F
– – – –
°C
Water Temperature is Unknown