4
Aurora Rack Mount Manual Adendum
1.
Pre-wire the input and output connectors on the back panel in accordance with the wiring drawings shown
below.
2.
Use the approved AC input power cord provided.
3.
Make sample inlet/outlet connections per instruction below and ensure they are leak free.
4.
19” rack mounting plates from Hammond Manufacturing (MPN: RM3U18BRKT) are pre-installed for customer use.
5.
The 3U rack-mount enclosure should be installed in the rack with screws at both the front and the back. Consult
rack manufacturer user manuals for proper installation.
3. Wiring the Aurora Rack Mount Configuration
All the electrical connections (input and output) to the Aurora RM are made via the back panel as shown in Figure 3
below. Please refer to the Aurora H2O User manual (P/N BH003C11 rev C) for detailed instructions on operating the
Aurora software via the front panel HMI.
Figure 3: Aurora RM back panel showing all customer connections and labels
These include the AC power inlet, analog and digital output connections via the DB-15 connector, and Cat5/Cat6
Ethernet cable. A custom I/O cable P/N 174M2304 is available as an accessory. Figure 4 shows the detailed pin-out of
the DB-15 connector used for all customer input and output connections.
Summary of Contents for Panametrics Aurora RM
Page 2: ......
Page 4: ...ii no content intended for this page...
Page 7: ...Preface v no content intended for this page...
Page 16: ......
