21
21
Belt Removal and Installation
1. MAKE SURE there is no power to the machine during
removal and installation of the belt.
2. Remove the spark trap from the front of the machine.
3. Remove the side cover by taking out the four hex bolts.
4. Rotate the belt tension release lever 90° clockwise (cw). This
action brings the spring loaded steering roller closer to the
contact wheel allowing you to place the belt around the wheels.
Note: The direction arrows on
the belt must match the belt travel direction.
5. Remove the old belt and center the new
belt on the wheels and then turn the belt
tension lever clockwise (cw) to tighten the
belt.
6. Close and secure the side cover.
7. Replace the spark trap to the front of the
machine and secure. (Make sure the
spark trap does not interfere with the
opening of the side cover.)
Belt Direction
Arrow