Baileigh Industrial DP-2012F-HD-V3, Operator'S Manual

Page: 27 / 40

25
25
Table Adjustment
The table can be adjusted for height, rotation and angle.
1. Loosen the support bracket lock knob. Turn the table
hand crank to lift or lower the table.
2. Always lock the support bracket in place before
operating the machine.
Adjust rotation:
1. Loosen the lock handle located under the table
2. Rotate the table the desired amount.
3. Always lock the table rotation in place before
operating the machine.
Adjust angle:
1. Turn the location pin nut in a clockwise direction.
This will draw the location pin out of the casting.
Once loose, pull the pin and nut out, and set it in a
safe place until needed.
2. Loosen the large pivot bolt in the center of the
support bracket above the location pin.
3. Rotate the bracket to the desired angle. Use the
scale on the side of the bracket or a protractor to set
the angle. Lock in place by tightening the pivot bolt.
4. When repositioning the table to 0° position, loosen the large pivot bolt in the center of the
support casting.
5. Rotate the support casting until the degree scale reads 0°.
6. Carefully tap the location pin back into the hole from which it came until it stops.
7. Unscrew the nut on the location pin until it is flush with the end of the threads. This will
protect the threads when you tap it into place with a hammer.
8. Carefully tap the location pin back into the hole from which it came until it stops.
9. Turn the nut clockwise until it is snug against the casting and then tighten the large pivot bolt
in the center.
10. The table is now set to the factory pre-set angle.