23
23
ADJUSTMENTS
Speed Changes
The drill press has 12 speeds. There is a speed chart
located on the inside of the upper belt guard. Refer to
the chart to align the belts to the correct pulley grooves
for the desired speed setting.
1. Unplug the drill press before changing speeds.
2. Loosen the belt tension lock knobs (A) on both sides
of the headstock by turning counterclockwise.
3. The motor should be free to move. Rotate the belt
tension lever (B) counterclockwise to take tension off
the V-belts.
4. Locate the desired speed on the chart and move the
V-belts to the desired V-grooves on the motor, idler
and spindle pulleys.
Important:
The belts must travel level
between the pullies. DO NOT allow the belts to travel up
or downward.
5. Rotate the belt tension lever until the belts are tight.
Tighten both lock knobs.
6. Close the cover.
WARNING:
Make sure the power cord is disconnected and power is OFF
before working on the machine.
Always follow proper safety precautions when working on or around any machinery.
A
B
Summary of Contents for DP-2012F-HD-V3
