Baileigh Industrial DP-2012F-HD-V3, Operator'S Manual

Page: 16 / 40

14
14
ASSEMBLY AND SET UP
Most of your Drill Press has been assembled at the factory, but some parts must be assembled
or installed after delivery.
Column/Base
1. Starting with the base (1), place the column (4) on the base and line up the mounting holes.
2. Insert and tighten the M10-1.5 hex head bolts (2) with a wrench.
Table Support
3. Install the 12mm table lock handle (16) 3 turns into the
table support bracket (large bore end).
4. Working from the inside out, insert the pinion gear (18)
into the hole on the side of the table support bracket so
that the shaft of the gear is visible to the outside of the
support bracket.
5. Align setscrew (7) in crank handle (6) with flat on pinion
gear shaft and secure the set screw to the shaft.
6. Examine the rack and note that the gear teeth extend
farther on one end than the other. The end of the rack
where the gear teeth are closest to the end should be
positioned down.
7. Insert the drive gear (17) and the rack (3) into the table
support bracket and align it with the pocket as shown.
The gear teeth on the rack must also face out.
8. Slide the table support bracket and rack assembly onto
the column while holding the rack in place.
9. Allow the bracket to go down until the bottom of the rack
contacts the shoulder on the column support casting.
10. Secure the table support arm with the clamping lock
handle (16).
WARNING:
For your own safety, DO NOT connect the machine to the
power source until the machine is completely assembled and you read and
understand the entire instruction manual.