BATTERIES
Charger
The charger is specially designed for charging
lithium-ion batteries. It is equipped with an inte-
grated fuse and protection against overcharging.
Keep the charger away from child ren and
animals. Small children and animals may
damage the cable while playing. This can lead
to an electric shock, a malfunction or a fire.
•
The charger must not be used by children, or
by persons with limited physical, sensory or
mental capabilities, unless under the supervi
-
sion of a responsible adult.
•
Make sure the charger is clean. There is a
risk of electric shock.
•
Do not use your charger in humid or dusty
places.
•
Avoid direct sunlight.
•
Disconnect the charger from the power sup-
ply when not in use.
•
Only use the charger that came with your
pedelec or one from the same manufacturer.
•
Don’t cover the charger while it is in use. It
could otherwise short circuit or cause a fire.
•
When you clean the charger, unplug it from
the electrical socket first.
•
When charging takes longer than shown in
the specifications table, stop charging.
•
After charging, remove the battery from the
charger and unplug the charger.
2.6 OPERATION
2.6.1
Installing the battery
For correct insertion, the battery must be
inserted and locked from the rear of the casing
as far as it will go. Without contact with the
battery, the electric drive of your pedelec will
not work.
1.
re inserting it into
the holder.
2. For the battery to be inserted, the lock must
be unlocked. You can lock and unlock the
battery by turning the key provided.
3. Slide the battery along the rail track into the
connector on the rail as far as it will go, then
turn the key to lock the battery.
Put the battery in its housing inside the
frame and press the lower part towards
the frame to lock.
4. Remove the key to avoid losing or breaking it.
2.6.2
Removing the battery
When removing the battery proceed as follows:
1. S
possible, the battery.
2. Unlock the battery.
Pull out of rack
3. Remove the battery f r om the casing/battery
holder.
Hold the battery tightly as it is heav y .
2.6.3
LED capacity and state
of charge indication
•
Press the button to wake up from Sleep
mode
•
Hold down the button for 5 seconds to
wake up from Deep Sleep mode
Then check the current charge level of your bat-
tery by pressing the on /
y.
The charge status is indicated by LEDs, which are
illuminated for d
rent charging states as listed
in the following table.
CONSUMER MANUAL
MAX DRIVE SYSTEM
CONSUMER MANUAL
MAX DRIVE SYSTEM
22
23
