CONSUMER MANUAL
MAX DRIVE SYSTEM
CONSUMER MANUAL
MAX DRIVE SYSTEM
DISPLAY (DP CO7.UART)
16
17
1.5.7
Automatic Off Time
When the speed field displays OFF, press
/
to
choose a figure between 1 and 9. The gures indicate
the minutes that it takes to automatically shut down
the display.
After this setting, briefly press
(< 0.3 seconds) to
enter the setting interface of maintenance warning.
1.5.8
Maintenance Warning
(can be deactivated)
When the speed field displays nnA, press
/
to
choose either 0 or 1. 0 disables the function while 1
enables it.
After this setting, briefly press
(< 0.3 seconds) to
enter the setting interface of password input.
Maintenance Warning Setting
The display will prompt maintenance necessity based
on such information as the accumulated riding dis
-
tance and the battery charge cycles.
• When the accumulated total riding distance
exceeds 5,000 km (can be customized by the
manufacturer), the display will show the symbol
. When the display is started up, the
sign for accumulated riding distance will flash
for 4 seconds, indicating that maintenance is
necessary.
• When the number of battery charge cycles ex
-
ceeds 100 (can be customized by the manufactu
-
rer), the display will the symbol
.
When
the display is started up, the sign for battery will
flash for 4 seconds, indicating that maintenance
is necessary.
•
The maintenance alert function can be disabled:
settings
maintenance alert (MA)
main
-
tenance alert (MA)
0. (Maintenance alert
can also be set via a computer. This requires a
USB connection. See also the parameter setting
instructions).
1.6 Error Code Definitions
The MAX-C966 display can show e-bike faults. When a fault is detected, the icon will be displayed. In the speed
field one of the following error codes will be displayed:
Error Code Error Description
Error-shooting Method
“03”
Brake enabled
Check whether a brake cable is stuck
“04”
T
he throttle has not returned home
Check if throttle has returned home
“05”
T
hrottle fault
Check the throttle
“06”
Low voltage protection
Check the battery voltage
“07”
O
vervoltage protection
Check the battery voltage
“08”
Motor hall signal cable fault
Check the motor module
“11”
Controller temperature sensor failure
Check the controller
“12”
Current sensor failure
Check the controller
“13”
Battery temperature fault
Check the battery
“21”
Speed sensor fault
Check installation position of speed sensor
“22”
BMS communication fault
Replace the battery
“30”
Communication fault
Check the controller connection
Error display
“10”
Stop the bicycle until the error code “10”
disappears from the screen
Note: Error Code 10 will probably appear on the dispaly
when the e-bike is climbling for a long time. This
indicates that the motor temperature has reached the
protection value, in which case the user needs to stop
the e-bike for a rest. If the user continues to run the
e-bike, the motor will automatically cut off the power.
The motor temperature has reached
the threshold
