BADU JET Wireless Control II, Translation Of Original Operation Manual

Page: 52 / 172

Commissioning
22 EN 06|2020
6.1.9 Clearing the security code on the hand-held transmitter
The security code on the hand-held transmitter can also be
cleared. The receiver-transmitter tuning will, however, be retained.
The radio command is still executed without entering the code
first.
Example for clearing a security code
– The security code (previous chapter) is to be cleared again.
1. Enter the security code: P5224466P5P
2. Both LEDs on the transmitter light up for 2 seconds.
6.1.10 Active time for the hand-held transmitter when operating with
security code
A command can be transmitted within 20 seconds without
entering a security code again. This can be switched on and off
with the command m
m. LED 2 flashes for the duration of the
active time (20 s). This function is useful when a dangerous
situation threatens (pool cover, garage door).
6.1.11 Transmission delay
Transmitted command can be delayed by x seconds. The
command m
xm must be entered to switch this on or off.
The transmission delay can last 1 – 9 seconds. The transmission
delay is useful when a user opens a door by remote control but is
only standing a few metres away.
6.2 Operation
6.2.1 Changing the colour of the LED floodlights in countercurrent
systems
The colour or colour mode of the coloured floodlights in the
countercurrent system cannot be changed immediately by radio
control. The radio command only allows the LED floodlight to be
switched on/off by the switch box board.
The colour is changed by switching off and back on within 7
seconds.
6.2.2 Changing the batteries of the hand-held transmitter
The transmitter is operated with CR123A (3V) batteries.
The eight screws on the back of the hand-held transmitter must
be removed to replace these. Pay attention to the + and – polarity
when inserting the batteries.