BADU JET Wireless Control II, Translation Of Original Operation Manual

Page: 51 / 172

Commissioning
06|2020 EN 21
• Left stop = toggle mode
If this setting is made before the receiver-transmitter tuning, the
appropriate relay pulls up at the first radio command. The relay
drops out (current surge function) with another radio command.
6.1.6 Special setting 4-channel receiver – defined OFF
Another button on the transmitter must be connected to this relay
if a relay that is in time mode/On is to be switched defined OFF.
To do this, the button is kept pressed for 15 to 20 seconds when
selecting the relay on the receiver until the LED assigned to the
relay flashes green.
Then the appropriate key on the transmitter can be pressed for
tuning.
6.1.7 Connecting other applications directly on the receiver
Other applications can be, for example:
•
Opening a garage door by a remote signal
• Starting a wave shower
This is possible because it is a secure and non-clonable rolling
code.
6.1.8 Assigning the security code on the hand-held transmitter
Each of the buttons 1 – 9 on the transmitter can be assigned a
security code. If, for example, a pool cover or a garage door is to
be activated by the remote control unit, it is advisable to protect
this against unsupervised use by children. The code must be
entered after pressing the respective key before the radio
command is sent.
The buttons 1 – 9 in chapter 3 must be used to enter the digits of
the security code.
The function of the countercurrent system is fixed on the two
bottom buttons because these must always be available. No
security code can be assigned to these buttons.
The security code can have between 2 and 7 digits. For the event
that you forget the personally selected code, the transmitter can
be reset with the reset code (label stuck to the transmitter).
 Keep the reset code in a safe place. Stick it in the receiver
switch box for example.
Example for creating a security code
– The wave shower (relay 4) is to be used on button 5 with the
security code 224466.
1. Connect button 5 to relay 4. See point 6.1.2 on page 19
2. Store the security code by entering: P5p5224466p
3. Both LEDs on the transmitter light up.
4. The switching function can only be activated with 5224466.