BADU JET Wireless Control II, Translation Of Original Operation Manual

Page: 50 / 172

Commissioning
20 EN 06|2020
6.1.3 Resetting the whole receiver
The receiver must be reset for security reasons if a hand-held
transmitter is lost. All settings must be reset to the factory setting.
This action cannot be cancelled!
Sequence 4-channel receiver:
1. Keep button A pressed for at least 40 to 45 seconds.
2. All LEDs light red.
Sequence 2-channel receiver:
1. Keep button 3 pressed for at least 30 seconds.
2. All LEDs light red.
6.1.4 Resetting the whole hand-held transmitter
The following sequence must be pressed if it becomes necessary
to reset the hand-held transmitter and thus all settings to the
factory settings.
1. M
2. P
3. Enclosed
9-digit code
4. M
5. P
The two LEDs light orange for two seconds as acknowledgement.
Buttons 1 – 9 in chapter 3 are used to enter the digits of the reset
code.
6.1.5 Special setting 4-channel receiver – time mode on/off
If the remaining relays of the receiver are not used for a BADU
countercurrent system, the other modes can be set with the
adjusting wheel B.
•
Left stop = touch operation (for countercurrent systems)
If this setting is made before the receiver-transmitter tuning, the
appropriate relay pulls up for about 1 second.
•
Middle position = timer, time switching 1 – 90 minutes
If this setting is made before the receiver-transmitter tuning, the
appropriate relay pulls up for the set time. Only an approximate
setting can be made with the adjusting wheel. The adjusting
wheel (B) can be readjusted slightly if the time is not correct after
a test. The receiver-transmitter tuning must then be repeated.