BADU JET Wireless Control II, Translation Of Original Operation Manual, Page: 43 / 172

Installation
06|2020 EN 13
5 Installation
5.1 Installation site
5.1.1 Installing the receivers
Both receivers are installed in an area outside the protection area
2.
The 2-channel receiver must be installed additionally in a switch
box.
5.1.2 Installing the transmitter
The transmitter is for hand-held operation but can be mounted on
the wall using the included wall rail.
5.2 Installation
5.2.1 Mounting the receiver
The housing can be mounted on the wall by means of the holes in
the housing. The holes are visible when the housing is opened.
Screws and plugs are included.
5.2.2 Mounting the remote control unit holder
The silver wall rail of the remote control unit can be mounted on
the wall using plugs and screws (included) if necessary. The
remote control unit can then be pushed into the holder and
screwed on if necessary. The fourth button from the bottom must
be removed for this. The button can be reinserted after tightening
the screw.
NOTE
The screw for mounting the remote control unit should only be
turned into the stop.
Fig. 4