31
29.04.2013 TB-b bta_bj_vogue_wave_engl_29042013.indd
Pool wall preparation for liner pools
27.0 .2010 TB-b beckenausschni t_fol enbecken_engl.ai
1) Fastening holes for clamping ring and jet housing (10x)
2) Fastening holes for nozzle housing (4x)
3) Fastening the jet housing to the wall (2x)
Nozzle
~250
~310
18°
4x90°(=360°)
TK Ø255
Ø233
3)
2)
1)
10x36°(360°)
18°
Ø7
Place the gasket with nobs (26) onto the jet housing (1), push in and position at the back of the pool
wall.
Working from the front, fasten the jet housing (1) to the pool wall using the 2 self-tapping screws
(103).
Then place the liner and use the 10 self-tapping screws (52) to attach the jet housing (1) to the pool wall
via the clamping ring (28) and the gasket for clamping ring (27).
Caution! Tighten the self-tapping screws to just hand tight. Do not use force!
52
1
Liner pools
Pressure tube
103
28
27
26
Fitting of the jet housing in liner pools
27.04.2010 TB-b montageanleitung_folienbecken_engl.ai
Fig. 5
Fig. 6
Caution! The jet housing
is made from ABS. If the
suction and pressure con-
nections are glued in-situ,
allow for a curing time of at
least 12 hours!
