41
HINT:
Clamp in position
before screwing.
GABLE TRIM
FINISH
Install (1)
HTA
1-1/4" up from front panel edge and center with panel seam
(Fig. A)
.
Secure the trim with (7) 1-1/4" screws from inside.
Secure with (2) screws at seam
(Fig. B)
.
Install second
HTA
1-1/4" up from
panel edge and fl ush to installed
HTA
(Fig. A)
.
Secure trim with (7) 1-1/4" screws from inside.
Install (2) screws at seam
(Fig. B)
.
Repeat steps 2-3 to install the back trim.
Your gable trim is now installed.
3
2
HTA
x4
2 x 4 x 59-1/8" (5 x 10 x 150 cm)
PARTS REQUIRED:
Pre-marked Line
AG
7" (18 cm)
Approximately
Fig. B
Fig. A
Flush
NOTE: Upper gable panels may be slightly offset from lower panels.
If this occurs, mark a line on upper panel to match lower wall panel (Fig. B).
x28
1-1/4" (3,2 cm)
1-1/4"
(3,2 cm)
Mark
1-1/4"
(3,2 cm)
It is important to secure the side wall in the following order.
Line up
seams.
HTA
