Backyard Discovery Highlander 6010, Owner'S Manual

Page: 27 / 60

PAGE 25
STEP 5
(when using Lag Screws make sure to pilot drill with 3/16”
drill bit.)
Making sure structure is level and plumb, attach two (2) E6 Deck Braces
Flush to top of H4 Floor Rail with 5/16”x 2-3/8” Lag Screws, 5/16” Lock
Washers and Fender Washers and to B1 Front Tower Legs with 5/16”x 2-
3/8” Lag Screw, 5/16” Lock Washer and 5/16” Flat Washer in counter sunk
holes.
Now attach two (2) E6 Deck Braces flush with top of H11 Floor Rails using
5/16”x 2-3/8” Lag Screws 5/16” Lock Washers and s and to
B1 Front Tower Legs with 5/16”x 2-3/8” Lag Screws, 5/16” Lock Washer
and 5/16” Flat Washer .
Now attach four (4) more E6 Deck Braces to B3 Back Tower Legs and G3
and G7 Floor Rails with 5/16”x 2-3/8” Lag Screws, 5/16” Lock Washers,
and 5/16” Flat Washers to Tower
Legs.
ANCHOR:
Position structure at this point making sure that all attachments will be
in the proper space for your yard.
Fender Washer
in counter sunk holes
Fender Washers in counter sunk holes
E6
E6
H11
H4
B1
E6
E6
E6
E6
G7
B3
B3
G3
G3
Position playset in permanent location and secure to ground. Measure in 4"
from Tower Legs and 4" from inside of G7 Base board and mark ground.
Now measure in 4" from Tower Legs and 4" from outside G6 Base Board
and mark ground. This should allow enough space to twist Stakes into
ground using screwdriver for leverage.
Twist Stakes until eye is approximately 3" from ground surface.
At this point you will need at least two people to slide the set into position
next to the Stakes. Using eye in Stake as guide drill thru Base Boards with
3/8" drill bit and attach Stakes with 1" Phillips Truss Head Bolts 5/16" Lock
Washers, s and 1/4" Barrel Nuts as shown.
Fender Washer
G6
G7
G7
Note: If your ground is loose, sandy or
rocky you may need to dig holes and
secure Stakes with concrete.
4”
4”
Metal Stake
FENDER
WASHER
BOLT
LOCK
WASHER
BO
ARD
FENDER
WASHER
BARREL
NUT
5/16"
Opposite side not shown.
ITEMS NEEDED
(8) E6 Deck Braces
(4) Y41 Ground Stakes
HARDWARE NEEDED
(24) 5/16” x 2 3/8” Lag Screw
(4) ¼” x 1” Phillips Truss Head Bolt
(4) ¼” Phillips Barrel Nut
(24) Fender Washer
(28) 5/16” Lock Washer
(8) 5/16” Flat Washer
5/16” Flat
Washers
5/16” Flat
Washers
5/16” Flat
Washers