Bacharach Parasense GRM2 CO2 Series, Operation & Maintenance Manual

Page: 23 / 97

3-2
Operation & Maintenance Manual
Doc. Ref. MNGRM2CO2 REV. 3
6) The existing setting
s for your PC will be shown. If the option ‘Use the following IP address’ is set,
take a note of the values that are shown onscreen. This information will be required at step 9 of
these instructions.
7)
Click on ‘Use the following IP address’. Enter the Gateway setting noted in step 1 into the Default
Gateway field. Enter the first 3 parts of the Address setting noted in step 1 into the first 3 parts of the
IP address field (e.g. if the Address noted was 192.168.0.50, then enter 192.168.0). In the 4
th IP
address field, enter a value which is different to the 4 th value of the Address noted in step 1 (e.g. if
the Address noted in step 1 was 192.168.0.50, then enter any value other than 50).
Note: there must be no other device connected to the same network with the same IP address
you have used (e.g. using the above screenshot as an example, there must be no other device
connected to the same network with an IP address of 192.168.0.9).
8)
Click ‘OK’, and close all previously opened windows.
9) Once all communication with the GRM2 CO2 is complete, change the PC settings back to the
previous settings by following the instructions above from step 2 to 7. The information noted in
step 6 must replace the data in step 7.
WINDOWS XP
1) Take a note of the current network settings of the GRM2 CO2 system (please refer to the Network
Settings menu of the Monitor Setup/Management Menu section for information).
2)
From the PC Desktop, access the control panel by clicking ‘Start’, ‘Control Panel’.
3)
Click ‘Network and Internet Connections’ followed by ‘Network Connections’.
6