75
MAG
User Manual v2.0
10. SENDING THE CONVERTER (COMPACT VERSION) TO THE MANUFACTURER
The device was manufactured with extreme care and passed rigorous tests before shipment from the
factory. If the installation and maintenance are carried out correctly, it is very unlikely that malfunction will
occur.
However, if it should be necessary to send the device to our customer service for any checks or repairs,
please pay attention to the following points:
•
According to the legal provisions on environmental protection and securing the health and safety of
our personnel, the manufacturer can only test and repair those devices returned to us that have been in
contact with products that are risk-free for personnel and environment.
• This means that the manufacturer can perform the service on the device only if this is accompanied by
the “Repair request form” (MOD.013 A) stating that the device itself (in the COMPACT version) can be
safely handled.
10.1 REPAIR REQUEST FORM
The RMA module (MOD. 013 A) must be requested to the B METERS support ([email protected]).
It must necessarily be filled in all its parts and attached to the delivery note document.
11. PRODUCT DISPOSAL
If you decide to put the converter out of service because it is definitely no longer in use, disconnect it
from the electrical power source (powered version) and from the connection cables to the sensor before
proceeding to its removal and its disposal.
Disposal of the device is the responsibility of the user who must comply with the specific laws enforced in
the country of installation regarding environmental protection.
MANUFACTURER’S STATEMENT
The manufacturer declares that the design, development and construction of the CONVERTER have been
carried out in compliance with the directive on the reduction of the use of dangerous substances with
particular attention to waste electrical and electronic equipment (WEEE) supporting, from an environmental
point of view and the protection of the health of the worker, the intervention of the subjects who participate
in the installation, use and disposal of their products (manufacturer, distributors, consumers, operators
involved in WEEE treatme
nt).
The cro
ssed-out wheelie bin symbol (Fig. 99) contained on the equipment indicates that the
product must be collected SEPARATELY from other waste at the end of its usefu
l l
ife.
Therefore, the user must give the equipment at the end of its life to the appropriate waste
collection centers for waste electrical and electronic equipment, or return it to the retailer
when purchasing a new equivalent type of equipme
nt.
Appropriate sorted waste collection for the next start-up of the disused equipment for recycling, treatment
and environmentally compatible disposal contributes to avoiding possible negative effects on the
environment and favors the reuse and/or recycling of the materials of construction.
Unauthorized disposal of the product by the user results in the application of the administrative sanctions
provided for by applicable law.
Fig. 99
