OPEARTING MANUAL
Technische Änderungen vorbehalten
B+B Thermo-Technik GmbH | Heinrich-Hertz-Str. 4 | D-78166 Donaueschingen
0141 0315-100 24.06.2022
Fon +49 771 83160 | Fax +49 771 831650 | [email protected] | bb-sensors.com
67 / 88
MV5
Selection of the
Output signal
. By pressing
Up
or
Down
the different output signals can be selected (see table).
E0.970
Setup of Emissivity. Pressing Up increases the value, Down decreases the value (also valid for all further functions).The
emissivity is a material constant factor to describe the ability of the body to emit infrared energy [►10 Emissivity].
T1.000
Setup of Transmissivity. This function is used if an optical component (protective window, additional optics e.g.) is mounted
between sensor and object. The standard setting is 1.000 = 100 % (if no protective window etc. is used).
A 0.2
Setup of
Average
time
. In this mode an arithmetic algorithm will be performed to smoothen the signal. The set time is the time
constant. This function can be combined with all other post processing functions. On 1M/ 2M/ 3M models the shortest value is
0,001 s (other models: 0,1 s) and can be increased/ decreased only by values of the power series of 2 (0,002, 0,004, 0,008,
0,016, 0,032, ...).
If the value is set to
0.0
the display will show --- (function deactivated).
P----
Setup of
Peak hold
. In this mode the sensor is waiting for descending signals. If the signal descends the algorithm maintains
the previous signal peak for the specified time. After the hold time the signal will drop down to the second highest value or will
descend by 1/8 of the difference between the previous peak and the minimum value during the hold time. This value will be
held again for the specified time. After this the signal will drop down with slow time constant and will follow the current object
temperature.
If the value is set to
0.0
the display will show --- (function deactivated).
V----
Setup of
Valley hold
. In this mode the sensor waits for ascending signals. The definition of the algorithm is according to the
peak hold algorithm (inverted).
If the value is set to
0.0
the display will show --- (function deactivated).
