Aybey Elektronik AE-LIFT Series, User Manual

Page: 13 / 53

4.5 POWER CIRCUIT TERMINALS
Terminals of power circuit are placed at the bottom side of the device. Detailed informations about
terminals are listed in Table 4.1.
Table 4.1 Power Circuit Terminals
POWER TERMINALS FUNCTION DEFINITION
L1, L2 ,L3 Line Inputs Connect 3-Phase line cables.
U, V, W Motor Outputs Connect 3-Phase motor cables.
P+, DB Braking Resistor Connect braking resistor cables.
L, N Supply of Control Circuit Connect 1-Phase line (100-240V AC) cables.
PE Earth Connect earth cable.
4.6 CONTROL CIRCUIT TERMINALS
Terminals of control circuit are placed at the right side of the device. Detailed information about input
terminals are listed in Table 4.2 and output terminals are listed in Table 4.3.
Table 4.2 Control Circuit Input Terminals
TERMINAL
FUNCTION DEFINITION
COM Common Common of input terminals. (0V)
V1, V2, ... , V6 Speeds Speed inputs
ENB Enable Enable signal of the device.
RST Fault Reset Reset fault message and gets device to normal mode.
FW Up Direction Up direction signal
RV Down Direction Down direction signal
RSC Rescue Mode Rescue mode input
I1 Programmable Input I1
Programmable Input 1
(Detailed information is in Section 8.5)
I2 Programmable Input I2
Programmable Input 2
(Detailed information is in Section 8.5)
I3 Programmable Input I3
Programmable Input 3
(Detailed information is in Section 8.5)
F/7.5.5.02.95 R:1 10
AE-LIFT