7
AXOR Industries
Service Manual
Magnum400
TM
ver.2 rel.05/'15
1.1 Description
digiTal inpuTs/ouTpuTs
9 digiTal inpuTs
They are programmable for: the limit switch, the holding
brake, the homing and positioning procedures, the emer-
gency stop, the reset alarm, etc.
standard
2 programmable
digiTal ouTpuTs
They can be used to send messages from pre-programmed
functions of the drive.
standard
emulaTed encoder
ouTpuTs
There are 6 pins dedicated to
emulated encoder
with
different programmed ratios (1/2, 1/4, 1/8, 1/16, 1/32,
1/64, 1/128) between output pulse/rev and encoder/
resolver ones.
standard
analog inpuTs/ouTpuTs
1 analog
common mode
inpuT (Tprc)
It is used for controlling the current from the drive.
standard
1 analog
differenTial or
common mode
inpuTs (+/-vref)
It is used for piloting the drive with an analogue speed
reference from an external controller.
standard
2 programmable
analog ouTpuTs
They allow you to visualise by the oscilloscope some of the
drive’s measurement values (for example: the velocity, the
Iq current, etc.).
standard
general feaTures
Keypad
four buttons
(
up
-
dw
-
mode
-
seT
) allow the manual
insertion of data without using a PC.
standard
display
A
display with 5 characters
visualises: the inserted
values, the drive’s status, the alarms.
standard
SPEEDER ONE
sofTware
inTerface
It allows you to set and manage all drive’s parameters by
using a PC connected to the drive.
The communication between the drive and PC is done by a
RS232 cable using the ModBUS protocol.
The software works on the following operating systems:
Windows 98, Windows 2000, Windows XP.
standard
