GROOVE / HOUSING JOINTS
8
Fig 06-07-08
• Max timber width - 290mm
• Min timber thickness - 10mm
• Max timber thickness - 25mm
Parts needed -
• Template B (sliding / half blind)
• Any straight cutter up to 14.5mm in diameter
• ¾” (19mm) Guide bush
Slot boards are cut horizontally
Groove Slot
Fig 03-04-05
Fig 01-02
1)
Attach comb B with the long groove slot at the front
of the jig, see fig 01, move both side stops to a central
position & lock in place, see fig 02.
2)
Mark a square line across the board where the centre
of the groove slot will be, load in & clamp the board
horizontally under the comb & up against the left hand
side stop, see fig 03-04-05.
3)
Ensure that the comb is sat flat & level on top of the
board, see fig 06. Use the wider part of the set gauge
to ensure that the marked square line is central to the
comb slot, see fig 07-08. Use the comb adjuster knobs to
align & adjust, see fig 09.
Side Stop
Square Line