Axminster SIEG Super X2 Mill, User Manual

Page: 4 / 32

What’s in the Box...
Model Number: XN2
1 No. SIEG Super X2 Mill with (1-13mm Chuck & B16 Taper)
1 No. Chuck Key
1 No. Tommy Bar
1 No. Morse Taper Drift
1 No. Oil Can
1 No. 8 x 10mm Double End Spanner
1 No. 12 x 14mm Double End Spanner
1 No. 3,4,5,6mm Hex Keys
2 No. ‘T’ Slot Keepers
1 No. Position Key
1 No. Spare Fuse
1 No. Guarantee Card
1 No. Instruction Manual
!
Please read the Instruction Manual prior to using your new machine; as well as
the installation procedure, there are daily and periodic maintenance recommendations
to help you keep your machine on top line and prolong its life. Keep this Instruction
Manual readily accessible for any others who may also be required to use the
machine.
Having unpacked your machine and its accessories, please check the contents against the equipment
list "What’s in the box", if there are any discrepancies, please contact Axminster Power Tool Centre
using the procedures laid down in the catalogue. Please dispose of the packaging responsibly, much
of the material is bio-degradable. The machine and its accessories will arrive coated with heavy
corrosion preventative grease. This will need to be cleaned from the machine, its components and
accessories prior to it being set up and commissioned. Use coal oil, paraffin or a proprietary
degreaser to remove the barrier grease. Be warned, it will stain if you splash it on clothing etc., wear
overalls, coverall et al., rubber gloves are also a good idea, as is eye protection if your cleaning
process tends to be a little bit enthusiastic. After cleaning, lightly coat the exposed metal surfaces of
the machine with a thin layer of light machine oil. N.B If you used paraffin/kerosene make sure you
apply this thin film sooner rather than later.
03
A
B
C
D
E
F
G
H
I
G
A
B
C
D
E
F
H
I