Axminster SIEG Super X2 Mill, User Manual

Page: 15 / 32

Operating Instructions...
D.R.O. Control
Digital Read Out (DRO) (Fig 5)
For normal drilling operations press the ON/OFF switch first, and then press the “ZERO” button. Press
“mm/in” button to select metric or imperial readings. These two buttons can be effected regardless of the
down feed handle position, then you can start drilling. The readings on the display can be amended at
any time by pressing “plus” or “minus” buttons.
When displaying error (e.g. no readings or flashing) it means the batteries are low and need replacing.
Push against the arrow showing in (Figs 5a & 5b) to open the battery cover, withdraw the battery for
replacement. The voltage of the Zinc button batteries is 1.2 volts. After replacement, re-fit the cover.
1.2 volt zinc button battery Removing battery cover
Plus & Minus
The readings on the display
can be amended at any
time by pressing “plus” or
“minus” buttons.
Min/in
Press “mm/in” button to
select metric or imperial
readings.
On/Off
For normal drilling operations
press the ON/OFF switch first,
and then press the
“ZERO” button.
Digital display
Fig 5
Fig 5a
Fig 5b
14