Axminster SIEG Super X2 Mill, User Manual

Page: 14 / 32

Operating Instructions...
1. Make sure the correct fuse is in the fuse box and the power switch is off. Unlock the emergency stop
button, connect the machine to mains and switch on. The power light on the control panel will come on.
2. When the machine is on, press the (start) button, the motor starts up. Press the button ( ) to
increase the speed, while pressing ( ) will decrease the speed. Press the ( ) to control the
forward rotation, while ( ) controls the backward rotation. Pressing the (TAPPING) button, will slow
down the spindle’s rotation to 0-500rpm, as above, and the word TAPPING will appear on the controls
display. The switches on the handles control the spindles rotation, forward and reverse. Pressing the
(STOP) button, will stop the machine.
Note: The circuit boards on the machine has an overload protection function. If the material you are
drilling or milling is over excessive volume, it will cause the machine to automatically stop and will
display an error message on the LCD, on the control panel.
Remove the material from the machine, reset the machine by switching the power switch on/off and
continue with operation.
Parts Identification
1. Power Light
2. Fuse
3. Emergency Stop Button
4. Control Panel
5. LCD Display
6. Power Switch
7. Speed increase Button
8. Speed Decrease Button
9. Forward Rotation Button
10. Backward Rotation Button
11. Tapping Button
12. Start Button
13. Stop Button
1
2
3
4
5
6
7
8
9
10
12
13
11
Control Panel
13