Axminster CT-90H, Manual

Page: 9 / 28

Assembly
9
Having unpacked the boxes, put all components where
they are readily to hand.
1. Locate the base (1-14), twelve UNC short bolts
(12j - 27i) and upright supports (3-16). Place one of the
supports (3-16) on to base and line up the pre-drilled
holes with the ones to the side of the base, lightly secure
in place with two UNC bolts, see fig 01-02-03. Repeat for
the remain support.
Fig 01-02-03
14
1
16
3
NOTE: MAKE SURE THE TWO HOLES TO THE TOP
OF THE SUPPORTS FACE OUTWARDS!
2. Locate the tube support bar (2-17), line up the two
holes with the holes to the front of base (1-14) and
lightly secure using two UNC short bolts, see fig 04-05-06.
27i
12j
Fig 04-05-06
17 2
3. Locate the extractor assembly (13-28), lower the
assembly down and insert the two upright supports
into the extractors mounting brackets to either side of
the assembly, see fig 07-08-09.
4. Line up the holes and secure in place using four UNC
short bolts (12j-27i) and the supplied spanner, 09-10.
NOTE: YOU WILL REQUIRE ASSISTANCE FOR THE
NExT STEP!
Fig 07-08
Fig 09-10
12j 27i
12j 27i
13 28
Mounting bracket
Continues Over....