Axminster CT-90H, Manual

Page: 12 / 28

Assembly
12
Extractor Filter
1. Locate the filter assembly ( 6-26) filter retaining belts
(8-24) and foam seal bands (7-25).
2. Put to hand the wide foam seal band, peal back the
paper backing, position the end of band up against the
underside of the upper lip on the extractor housing and
firmly press down to secure in place. Carefully peal back
the backing guiding the seal band round the extractor
until it overlaps, use a knife to cut off any excess, see fig
25-26-27.
Fig 25-6-26-27
3. Go round pressing down the band to make sure it’s
stuck firmly down. Locate the filter assembly (6-26), lower
the filter down over the extractor opening until it’s firmly
down, see 28.
4. Straighten the filter retaining belt (8-24), position the
belt around the base of the filter and latch it down to
hold and to seal the filter assembly, see fig 29-30.
Fig 28
Fig 29-30
5. Locate the remaining foam seal band, peal back the
paper backing, position the end of band up against the
edge of the lower lip of the extractor housing pressing
firmily down, see fig 31.
6. Work the band around the extractor as before, find the
dust bag (5-19) and the remaining retaining belt. Open
up the dust bag and place it up and over the lower
extractor housing, see fig 32.
7 25
Paper backing
Upper lip
6
26
24
8