Axminster CT-90H, Manual

Page: 10 / 28

Assembly
10
5. Locate a further two UNC short bolts and secure the
front support bar (2-17) to the extractor assembly (13-28),
see fig 11-12.
Fig 11-12
6. Locate the tube handle (4-15), medium washers
(12g- 27f) and 5/16" UNC Hex bolts (long) (12k-27j).
7. Place a washer over the bolts, line up the holes in
the tube handle with the threaded holes on top of the
mounting brackets, inset the bolts and secure the handle
to the extractor assembly with the supplied spanner,
see fig 13-14.
Fig 13-14
12g
12k
27f
27j
4
15
8. Lower the assembly down to the floor, note you may
require assistance as the motor assembly is heavy.
Wheels/ Castor Wheels
Locate the following: wheels (10-21), castor wheels
(11-22), 5/16” UNC domed cap head bolts (12i) , eight
5/16” UNC Hex bolt (27i), 1/2” nuts (12c & d), (27c), nylon
washers (12f & 27d), thin washers (12e & 27e), large
washers (12h & 27g) and large 1/2" Hex bolts (12l & 27k).
1. Put to hand the castor wheels, line up the holes in the
brackets with the pre-drilled holes to the extractor’s base
and secure with domed bolts (12i) for (CT-90H) and Hex
bolts (27i) for (CT-90HB), see fig 15-16.
Fig 15-16
12i
27i
11
22
17
2
2. Place a large washer over the 1/2" hex bolts (12l & 27k)
and slide the bolt through the centre hole to the front
NOTE: USE THE HANDLE, 4-15 TO LOWER THE
ExTRACTOR TO THE FLOOR.
Fig 17
12h
12l
27g
27k