Axminster CT-90H, Manual

Page: 11 / 28

Assembly
11
of one of the wheels, see fig 17. Turn the wheel over and
place a nylon washer then a thin washer down over the
thread of the Hex bolt, see fig 18.
3. Lower the wheel assembly down and slot the hex bolt
through the pre-drilled holes to the side of the extractor’s
base, see fig 19.
Fig 18
Fig 19-20
CT-90H Extractor Only
CT-90H Extractor Only
Before sliding the Hex bolt down through the
second hole, screw on an 1/2" Hex nut (12d) onto
the thread, see fig 20.
Tighten the Hex nut (12d) up against the angled
bracket, see image above.
4. Locate the 1/2" locking nuts (12c & 27c) and screw it
onto the thread, see fig 21 then tighten using two
spanners or open-ended sockets, see fig 22.
Fig 21-22
5. Repeat steps 2-4 for the remaining wheel assembly,
see fig 23-24. Stand the extractor upright.
12f
12e
27d
27e
12d
Fig 23-24
Continues Over....