Maintenance
17
Fig 35-36
Fig 33-34
Head Stock Adjustment
If there is sufficient play happening in the head stock
assembly, loosen the three locking Hex bolts (E) to the
right side of the head stock column and carefully adjust
the three gib strip screws (F), see figs 35-36.
NOTE: make small adjustments, pulling the operating
lever down until the head stock slides smoothly up and
down the column, but not to much causing the head
stock to tighten or jam.
When you feel the slide play has been eliminated tighten
the three locking Hex bolts (E) on the column to secure
the setting.
D
C
F
E
General Maintenance
WARNING!! DISCONNECT THE MORTICER FROM
THE MAINS SUPPLY BEFORE CONTINUING!
To ensure optimum performance from your morticer
routine cleaning and lubrication is required.
After long periods of use wood and resin deposits will
build up on the table and the rack and pinion gears. Clean
all surfaces using “Axcaliber Blade and Bit Cleaner Code
951145” then apply a light application of lubricant to all
moving parts using “Axcaliber Dry Lubricant Code 503468”.
Continues Over....
Code: 951145
Code: 503468
Locking Hex bolts
Gib strip screws
