Setting Up the Morticer
13
The table camp can be adjusted to accommodate
different sizes of timber using the pre-drilled holes in
the table. Using a spanner remove the two bolt and
washers and place safely aside. Re position the clamp
assembly to the desired position and replace the two
bolts and washers and tighten, see fi gs 19-20-21.
Table Clamp
Adjusting the Table
Fig 19-20-21
The work table can be adjusted from back to front and
from left to right by the operating the, main control wheel
to the front of the morticer.
Left to Right Movement
Push the operating wheel forward to engage the drive
gear into the table rack thus enabling the table to move
from left to right, see fi gs 22-23-24.
Fig 22-23-24
Continues Over....
Gear meshed with table rack
