Axion AC-AXION-4, User Manual

Page: 8 / 54

8
Initial Setup: WebUI
1� With the AC-AXION-4 placed into its new home (AV Rack, cabinet, table top) take a Phillips
head screwdriver and attach the included yellow ground strap to the back of the chassis using
the pre-installed screw, then attach the other end to a suitable grounded object�
2� Connect the HDMI Input sources to the HDMI Inputs on the back of the matrix�
3� Connect the HDMI/HDBaseT devices to the HDMI/HDBaseT Outputs�
4� Connect the network LAN cable to the RJ45 port labeled LAN (between the Micro USB and 3pin RS232
port)�
5� Power on the sources (Inputs)�
6� Power on the Output devices/displays�
7� Connect the 48V power supply to power on the matrix and then to a suitable power source�
8� Using the front panel display and control/arrow buttons navigate to NETWORK and press
the OK button to enter the IP Settings menu�
9� Either manually enter in your desired IP settings, or enable DHCP and let your network assign the
correct settings� Use the UP/DOWN arrow keys to highlight the row you want to change (HIP, RIP, TCP
Port, etc), click OK, use left/right arrow keys to select and the UP/DOWN arrow keys to change the
setting. Click the OK button again to confirm those changes.
10� With the matrix connected to the local network, using a computer on the same network open up a web
browser and type the HIP (Host IP Address) into the address bar to navigate to the WebUI�
The AC-AXION-4 can be controlled using the Micro USB port, 3pin RS232, or over TCP/IP using the LAN
connection� For initial setup it is recommended to connect the matrix to a local area network (LAN) and use
a computer on the same network in conjunction with the built in WebUI� After making all the physical con-
nections, the first step will be to check for any Firmware Updates. The below steps are an example of this
setup, other control options are covered in separate sections of this user manual�