Axion AC-AXION-4, User Manual

Page: 38 / 54

38
IR NOTES (On the Matrix):
1� By default the IR IN is routed to the corresponding HDBaseT Output number (ie. IR IN #1 --> HDBaseT
Output 1, IR IN #2 --> HDBaseT Output 2, etc...)
2� By default the IR OUT is automatically routed with the active source (ie� If you are watching INPUT 3
on HDBaseT OUTPUT 1, when you point a remote at an IR Receiver on the HDBaseT Rx connected the
signal will be routed to IR OUT 3)
3� Each IR IN can be routed in any way you like (One to one or one to many) by using the command SET
IRC EXT SW x1�x2�x3�x4 (See below)�
4� Each IR OUT can be routed manually as well using the command SET IRC OUTx VS INy� This can also be
controlled by the Web Interface
IR NOTES (On the HDBaseT Receiver):
1� IR OUT = IR Emitter for sending signals to a Display or Projector (Note - Use Provided Emitters)
2� IR IN = For sending IR signals back to the Matrix for switching AND to send IR signals to the IR OUT on
the Matrix - by default the IR OUT on the matrix is automatically routed with the active source (ie� If you
are watching INPUT 3 on HDBaseT OUTPUT 1, when you point a remote at an IR Receiver on the HDBa-
seT Rx connected the signal will be routed to IR OUT 3)
Direct connection to a control system - Set the switch to “I-PASS” to connect directly to a control system�
TIP - Signal
Sleeve - Ground
TIP - Signal
Sleeve - Ground
Control4 Wiring
Example