Axiom CNC Series, Assembly Manual

Page: 14 / 29

14
3- When the Router Table is securely fixed to the enclosure base and stand assembly
you can then proceed to tighten the 4 bolts at each end of the stand cross members.
Figure 19 Stand cross member bolts
4- Now is a good time to place your control box into its correct location in the toolbox
and feed all the connection cables through the hole at the back
Figure 20 Axiom Controller in toolbox Figure 21 Connection Cables
5- Connect the two barrel connections to the back of the Router Table as per Figure 22.
Leave the mains plug disconnected until the full enclosure assembly is complete.
Figure 22 Machine Connections
Step 2 is now complete.