Axiom CNC Series, Assembly Manual

Page: 13 / 29

13
1- Position router over the stand and align holes on router mounting flanges and the enclosure
base assembly holes being careful to make sure the stand is properly oriented with the
machine front. Stand front is the side you placed the toolbox in as per Figure 17.
Figure 17 Installing the Router Table on the Stand
2- Place rubber bushing over the holes in the stand. Lower the machine to sit on the
bushings.
a. Attach the machine to the stand using M10 Hex bolt provided with washer at
each corner.
b. Insert the bolt/washer through the machine mounting flange and the rubber
bushing.
c. Thread the bolt loosely into the stand mounting holes. Do not tighten until all
bolts have been threaded. This ensures correct alignment.
d. Remove fork lift and tighten bolts evenly.
Figure 18 Correct fixing of router table to stand assembly