Page 20 of 28
Axicon Auto ID Limited | inline verifier user guide | Dec 2018
Axicon 6525-S, 7025-S
Cradle setup
The verifier is then positioned into
the baseplate by inserting it front
first and positioning it against the
two stops on the cradle.
The rear of the verifier is then
lowered and it is held in place by
the sprung-metal clip at the rear.
The longer end of the baseplate
should then be positioned under
the thermal transfer printer.
The height of the cradle is fully adjustable. To alter the height simply release the
knurled screws, raise or lower the height of the cradle assembly and then re-tighten
the screws.
When in use the labels should pass from the printer, over both of the rollers in the
cradle assembly and then back to a rewinder.
The easiest way to feed labels through the verifier assembly is to lift the verifier
out of the cradle, pass the labels over the rollers and then put the verifier back into
place.