Room Alert 4E
SNMP Configuration
To begin configuring your Room Alert 4E for SNMP:
1.
In “Community Name,” you may leave the default SNMP protocol community name—
“public”—or enter a new name.
2.
You may leave “Contact (sysContact)” blank or enter a person’s name to specify who is
receiving the information.
3.
You may leave “Location (sysLocation)” blank or enter the location of your Room Alert
4E monitor.
4.
You may click
Use 2 digit SNMP
if you prefer to receive values in 2-digit rather than
4-digit format.
Then continue on to the
SNMP Sending Configuration
or
SNMP Receiving Configuration
section of the page, explained below.
TIP
The community name you assign here must match the one in
your 3
rd
-party SNMP monitoring application.
TIP
Room Alert 4E sends values to your 3
rd
-party SNMP monitoring
application in 4-digit format by default. 78.55° F, for example,
appears as 7855. In 2-digit format, your values are truncated,
not rounded to the nearest number. In this example, 78.55
would appear as 78.
AVTECH Software, Inc.
21
