AVS Electronics FOGGY, Manual

Page: 34 / 60

- 34 -
ER 190 (1 x 90°) Supplied: this nozzle is the one installed by the manufacturer, it
has a straight spray, uniform and long range.
Dispensers
ER160 (1x60°) Optional: it has a jet tilted 60°, long range; this type of dispenser
nozzle makes it possible to install Foggy in different positions.
ER390 (3x90°) Optional: allows short range dispensing in 3 different directions; it
divides the jet into two tilted at 30° and one tilted 90°. This type of dispenser allows
installing Foggy and creating a tent effect protection, for example for protecting full
length windows.
ER360 (3x60°) Optional: allows dispensing a short range triple jet with the
characteristic of spreading the fog effect uniformly.
Foggy is supplied with dispenser Mod. ER 190 but it is possible to replace it with one of the other models (optional)
described here below:
In order to replace the dispenser, carry out the following steps:
w unscrew and remove the installed dispenser using an 11
mm hex closed end spanner
w cover the threading of the dispenser being installed
with the ceramic paste supplied with the actual
dispenser
w screw the dispenser being installed using an 11 mm hex
closed end spanner, checking that the holes are positioned
correctly (see reference figure based on the model used)
Tank
The 1.5 litre tank guarantees autonomy for multiple activations; it is made in steel and allows recharging the fog fluid
(to be carried out by the manufacturer). The fluid is not under pressure, but it is kept under vacuum, this in order to
safeguard its duration over time, avoiding alteration of chemical characteristics.
Fluid level is constantly monitored thanks to a dedicated
sensor that communicates with the electronic board and
warns if the level is low.
Connect the tank to the specific
coupling.
Fasten the tank using the supplied
reusable strap.
Connect the cable of the Liquid
Sensor on the F. SENSOR in the
management board.
After carrying out operational tests, it is recommended to replace the tank with
one that has not yet been used in order to guarantee the maximum number of
deployments based on the selected type of operation.
The tank must be regenerated exclusively by AVS Electronics therefore, in order
to avoid having an environment unprotected by Foggy while waiting for a
recharge, it is recommended to keep an emergency tank.
E
N
G