AvMap G7 Farmnavigator, User Manual

Page: 45 / 80

45
AvMap G7 Farmnavigator – User Manual
4. Advanced operating modes
This chapter describes advanced operative functions.
4.1 Start new job, full mode
To start a new job in full mode, it is necessary to insert all the information required for a correct
registation of a new job:
1. Select “START NEW JOB”;
2. At “FARMER” line, tap the downward green arrow and select the farmer’s name;
3. At “
FIELD” line, tap the downward green arrow and select the field. In case of undefined
field, tap on “Create New” and follow the procedure for inserting a new name;
4. At “IMPLEMENT” line, tap the downward green arrow and select implement’s name;
5. At “DRIVER” line, tap the downward green arrow and select driver’s name;
6. At “
PRODUCTS” line, tap the downward green arrow and select the name of the product. It
is possible to select more than just one product for every single job;
7. Select “OK” to go to work page;
8. Tap the “i” located at the upper left corner of the display to edit Job name:
1. Tap the pen icon to modify the text;
2. Select “OK”;
3. Tap on the downward green arrow to go back to the previous page;
4. Tap on “A-B” to start the job.
4.2 Define the field and create new A-B guidelines
During the definition of the field, it is possible to create A-B guidelines to work the area inside the
field boundaries. This procedure is to be used the first time you define the field.
In this way an A-B line is created in conjunction with the passage of the tractor on that side of the
field, avoiding unecessaries overlaps.
- Create a new Job, preferably in full mode.
- Move to the edge of the field;
NOTE : It is advisable to change the name of the job. In order to do so, tap on “i” located at the top
left corner of the display.
-Tap “START” if the area must be worked during the recording of the boundaries;
-Tap “
FIELD” and move along the perimeters of the field;
-On the Job side, tap “A-B”;
-Select the line type;
-Proceed straight ahead to save point B;
-Tap B and proceed straight ahead to close the contour;
-Tap “FIELD” to complete registration, when you are in proximity to the starting point;
-
The field takes the name defined during the new job creation page. Tap “EDIT” if you want
to modify it;
-Field boundaries will be saved and stored.