AVL DITEST HV SAFETY 2000, User Manual

Page: 40 / 58

Performing a measurement AVL DiTEST HV Safety 2000
3-20 User manual
3.11 Full measurement
“The “
Full measurement
” mode combines the following measurements into one user-guided
procedure:
1. Prepare vehicle for the measurement
2. Verification of zero-potential
2.1 HV+ measurement against HV-
2.2 HV+ measurement against Chassis
2.3 HV- measurement against Chassis
3 HV Insulation measurement at the zero-potential system
3.1 HV+ measurement against Chassis
3.2 HV- measurement against Chassis
4. SAE J1766 measurement on the live system
4.1 Battery voltage measurement HV+ against HV-
4.2 Insulation measurement HV+ against Chassis
4.3 Insulation measurement HV- against Chassis
1.
When you click on the Full measurement mode (see Fig. 3-1), a screen of safety instructions
will appear. You must read and observe these safety instructions.
2. The AVL DiTEST HV Safety 2000 safety test is carried out:
- Connect the probe tips briefly
- Press and hold the test button on the red test adapter until the safety test has completed
- The result of the safety test is displayed
3. Proceed as instructed on the screen.
As the procedure is menu-driven, a detailed description is not provided here.
Please refer to the description for the “
Voltage measurement
”, “
HV insulation measurement
”
and “
SAE J1766 measurement
” modes in sections 3.1, 3.4 and 3.5.
4.
At the end of “
Full measurement
” mode, the combined result of all measurements is displayed.
5. Clicking on F6 Report creates a report of the measurement results (see chapter 3.1).
6.
To repeat the “
Full measurement
”, click on
F8 Next or press and hold the test button on the
red test adapter.
7. << Cancel
cancels the “
Full measurement
”.
If no stable measured value is displayed:
- Start a new measurement
- Press and hold the test button on the red test adapter until a stable measured value is
displayed
- If necessary, restart AVL DiTEST HV Safety 2000 or AVL DSS
NOTICE