Avigilon ACC, Initial Setup Manual

Page: 20 / 46

Setting Description
in the scene, like moving shadows, cause tampering events. If the camera is
installed indoors and the scene is unlikely to change, you can increase the
setting to capture more unusual events.
Trigger Delay:
Enter a value between 2-30 to define how many seconds the camera will wait
before sending tampering events. The default value is 8.
If the tampering ends before the trigger delay time has elapsed, no tampering
events will be sent. If the time elapses but the tampering has not stopped, the
events will be sent by the camera.
Enable Self Learning
Select the checkbox to enable self-learning. If you clear this checkbox, more
classified objects may be falsely detected.
Video Analytics Mode
If your device supports Unusual Motion Detection, you can enable Classified Object or Unusual Motion
mode for a video analytics device.
Tip: If your device is connected to a server that provides Classified Object Detection, you can
enable both analytics modes simultaneously. In the device Setup tab enable Unusual Motion mode.
In the server Setup tab enable server-based analytics. See
Enabling Analytics on page 17 .
1. In the New Task menu
, click Site Setup .
2. Select a device, then, click
General .
3. In the Video Analytics Mode: drop-down list, select one of the following:
l
Classified Object — Detect and classify people or vehicles.
l
Unusual Motion — Detect unusual pixel motion based on typical speed and direction of
movement in a scene.
l
None — Do not use analytic capabilities.
4. Click OK .
Configuring Rialto Video Analytics Appliances
To use a Rialto video analytics appliance, configure each connected camera channel for video analytics
detection.
If you are configuring an analog video analytics appliance, ensure the cameras are physically connected to
each camera channel before connecting the appliance to the system.
If you are configuring an IP video analytics appliance, any camera on the network can be digitally connected
to the appliance camera channels. Before you complete this procedure, connect the required cameras first.
Video Analytics Mode 20