EN
50
4.1 - MANUAL CONTROL
You can manoeuvre the gate with no programming,
for example during installation, to check the opening
direction is correct.
•
To enter manual mode, press
“SET”
for 3
seconds and LED L3 will flash.
• Press and
hold
the appropriate button
(
“–”
to
close,
“+”
to open) for the desired movement.
•
To finish, press the
“PROG”
button.
•
Otherwise, after a minute with no action on a
button, the system will automatically exit manual
control.
0RGHPDQXHO
/
/
/
/
/
²
0(18
6(7
T
352*
IHUPH
RXYUH
Manual mode
closes
opens
4.2 - TOTAL RESET
You can reset to factory settings.
•
To do this, press
“SET”
,
“–”
and
“+”
at the same
time and hold for 8 seconds until an LED display
appears. All the settings now have their default
value and you must redo the self-learning.
However, this procedure does not delete the remote
controls from the memory.
5 - REPLACING THE REMOTE CONTROL
BATTERY
When the remote control range is very reduced and
the red indicator is weak, this means that the remote
control battery will soon run out.
The remote control takes CR2032 batteries.
Replace the battery with a battery of the same type
as originally used.
•
With a Philips screwdriver, remove the 3 screws
behind the remote control.
•
Open the remote control and remove the
batteries.
•
Insert the new batteries, respecting the polarity.
•
Close the remote control and screw in the
fastening screws.
6 - REPLACING THE POWER FUSE
•
Switch the motor drive off.
•
Use a 250V 1A time-delay fuse.
F - MAINTENANCE AND UPKEEP
CONNECTED MOTOR DRIVE KIT
